Small Hole Cover SHC250 Push Fit

These small hole covers are perfect for use on construction sites, covering holes with a diameter up to 210mm or square holes up to 200mm square. They immediately cut the risk of injury from trips and twisted ankles as they blank the opening off. They have been independently tested, showing they can withstand up to 150kg (23 ½ stone) being applied over an area the size of a heel.

Installation of the small hole cover takes no time at all. Simply squeeze the two legs on the underside of the cover together and push it into the hole. The legs push back out, locking the plate into position.

Not only does this quick-to-install plate prevent trips, but it can also prevent tools and other small equipment from accidentally dropping down openings and into drainage holes in upper floors, where they could fall from height, causing injury to those working below. Should you need to cover 

• Overall Size 250x250mm
• Maximum Hole Diameter 210mm
• Maximum square hole 200mm
• Load capacity 150kg