Small Hole Cover LHC350 Bolt Down (350x350mm)

This small but mighty hole cover is designed to cover 300mm square or 300mm diameter holes in floors on construction sites. It is screwed into place through its pre-drilled corner fixing points. 

Able to withstand a load up to 180kg over an area the size of the average boot heel (90x80mm), this strong plate can prevent accidents such as slips, trips, broken ankles, and worse with minimal effort. Once removed, it leaves little evidence it was ever there, causing no further work.

When installed on upper floors of buildings, it can effectively prevent tools, fasteners, and debris from falling onto those working below. Overall, this is a very cost-effective safety product that will save time and reduce the risk of injury on-site.

• Overall Size 350x350mm
• Maximum Hole Diameter 300mm
• Maximum square hole 300mm
• Load Capacity 180kg
  

Please Note: Although this hole cover is tested to withstand 180kg over an area the size of a boot heel, the plate comes with a marking for "no step"; this is to discourage workers from treading on the board where possible.