Curved Direction Arrow Stencil For Pedestrian Guidance - Kits Available

Curved Direction Arrow Stencil For Pedestrian Guidance - Kits Available (2 x White Cans Temporary Paint)

Curved Direction Arrow Stencil For Pedestrian Guidance - Kits Available (2 x Yellow Cans Temporary Paint)

Curved Direction Arrow Stencil For Pedestrian Guidance - Kits Available (2 x Red Cans Temporary Paint)

Curved Direction Arrow Stencil For Pedestrian Guidance - Kits Available (2 x Blue Cans Temporary Paint)

Product code: 14975

Curved Direction Arrow Stencil For Pedestrian Guidance - Kits Available

Start Traffic

View the product details

£13.12 excl. VAT

£15.74inc. VAT

Buy in bulk and save

10 or more £12.50 excl. VAT
10 or more £15.00 inc. VAT
20 or more £11.99 excl. VAT
20 or more £14.39 inc. VAT

In Stock

Include Paint: No Thanks (No Paint)

Size guide

No Thanks (No Paint)
2 x White Cans Temporary Paint
2 x Yellow Cans Temporary Paint
2 x Red Cans Temporary Paint
2 x Blue Cans Temporary Paint

Call us for bulk quantities (0)1905 794875
View the product details below to learn more about this product.

You may also need the following:

£13.12 excl. VAT

£15.74inc. VAT

Curved Arrow Spray Paint Stencil

This plastic curved arrow stencil can be used for creating easy to follow direction markings outdoor. This may be for creating a one-way route for social distancing, or for entrance directions at an event.

The stencil is made from a relatively stiff plastic that can be cleaned with solvent cleaners and used over and over again. We recommend using this stencil with temporary paint such as LMP. This will ensure that the markings are not permanent once they are no longer required.

The direction of this arrow can be reversed by turning the stencil over, care should be taken to make sure that any paint residue on the other side is dry though, to ensure smudges are not made on the floor.

Painting Application Guide

Sweep the area – this removes loose dirt that wastes paint (if the dirt blows away so does your marking) it also allows the stencil to sit flat to the floor.
Lay the stencil onto the ground – the stencil should sit flat to the floor and works best on flat surfaces, good results can still be achieved on rougher surfaces too.
Thoroughly shake up the LMP paint – this mixes the paint and ensures that you get a good consistent marking.
Spray the stencil - Pressing the stencil to the ground (especially important on rougher surfaces) spray the marking, keeping the can close to vertical. This paint lightens up considerably after drying (it can appear a bit dull during the painting process). Go over the marking until all areas of the marking are painted.
Lift the stencil – once all areas are evenly coated lift the stencil from the bottom edge trying not to drag it over any wet paint.
Leave to dry – the paint takes approximately 10 minutes to dry depending on the temperature, during this time the paint may smudge or lift if trodden in or touched.

Social distance stencil being pressed down during painting

Need a Custom Stencil?

Give us a call, all we need is vector artwork and we can get them produced for you, a minimum order quantity will apply.