🍪 Tasty Cookies: This website uses cookies to improve your experience. You can opt in or out. See our privacy policy.  

Cycle Symbol Road Marking | Colour & Size Options

  • £10.15 Ex VAT 
  • Inc VAT: £12.18
Product Code
Choose Option
Looking for larger quantities?

  • Secure Shopping High Security Checkout.
  • Installation Available Find out more

Available Options


  • Availability: Choose an option...
  • Brand: Start Traffic

Cycle Symbol Marking Diagram 1057

This bike road marking is used to indicate that an area is part of a cycle route, this could be both on-road or off-road in cyclists only areas. For use on road, this symbol is most commonly seen along the road’s edge where a specific area is designated for pedal cycles. You will also commonly find this symbol at traffic lights in front of the stop line, indicating a safe area designated for cyclists to stop at lights.

This marking is part of a larger range of cycle route signage and permanent thermoplastic road markings that we have available to purchase.

The recommended spacing for this symbol depends on its location there is some handy information from transport for London which can be found here. http://content.tfl.gov.uk/lcds-chapter6-signsandmarkings.pdf It is advised that this marking is placed at road junctions where a cycle lane is present and drivers of motor vehicles need warning of cycles.

Cycle Lane in London

Key Features Of Our Preformed Thermoplastic Bike Symbols

  • Easy Application - No special knowledge, talent or years at art school required, just a clean surface and a gas heat gun.
  • Professional Appearance - These markings always look good due to their pre-cut design.
  • Fast To Install - Minimal surface preparation is required for these markings, with a worst-case scenario requiring an application of primer.
  • Non-Slip - Apply glass bead to enhance the traction of your marking, both for pedestrians and vehicles.
  • Conforms - BSEN 1871

Choose From Tri-Colour or MonoChromatic Bike Lane Symbols

Dual-Colour

If you want this symbol with a blue background this is the option for you. Please note that these signs have no legal standing and should be used for cycle-specific areas only.

MonoChromatic

These markings only use white and have no background to them. These are used for on-road cycle routes and repeater markers.

Choose From An Array Of Sizes

Depending on the application you may require an array of cycle route marking sizes. We can provide any size required, but keep an array of “standard” sizes ready to go.


Applying Cycle Symbol 1057 In Thermoplastic

Applying our cycle symbol markings is very easy. Firstly the area must be cleaned of all loose debris, oil, grease and salts. Once this is done you are ready to get going. If your road surface is old tarmac, concrete or block paving then you will need to use our fast-drying primer.

Once you have fully prepped the surface the marking can be set out. Once you are happy with the marking positioning a heat gun can be used to melt the marking to the road surface. For additional traction glass bead can be sprinkled over the surface, this is fused into the marking with the further application of heat.

Thermoplastic On Block Paving

Thermoplastic on block paving is known to be more difficult to apply and has a substantially shorter lifetime than on bituminous surfaces, such as tarmac.

Block paving is not a solid structure. Most of the time, they are put down and sand is added into the grooves, so over time when moisture creeps in as well as moss, movement can be made within 2 blocks, making the material crack and fail.


Need Assistance?

Cannot find the bicycle symbol marking you are looking for? We are here to help, our trained staff are available throughout the day to take your calls or answer your messages. They will ensure that you get the best marking at the best price. Our phone lines are open during normal office hours.


Customers Who Viewed This Page Also Viewed


Specifications

Certifications
Conforms BS EN 1871
Material
Type Thermoplastic
Miscellaneous
Application If using glass bead, 250g of glass bead per square metre

Downloads


Customer Questions & Answers

Be the first to ask a question.

Contact Us

Weekdays 8:30AM to 5PM

Address:

Start Safety, Drury Lane,
Martin Hussingtree,
Worcester, WR3 8TD

Phone:

+44 (0)1905 794875

Email:

Send Us An Email

Testimonials

Where We Are

Google Maps